1. 使用自带数据线连接NMC，配置tebby串口连接

nmc.png2. 使用命令登录并配置固定IP，并重启

 Serial  Port opened

User Name : apc
Password  : ***

Schneider Electric                      Network Management Card AOS    v2.0.0.6
(c) Copyright 2021 All Rights Reserved  Smart-UPS APP                  v2.0.0.5
-------------------------------------------------------------------------------
Name      : apc8CE746                                 Date : 07/01/2024
Contact   : Unknown                                   Time : 18:12:20
Location  : Unknown                                   User : Super User
Up Time   : 0 Days 18 Hours 1 Minute                  Stat : P+ N4+ N6+ A+
-------------------------------------------------------------------------------
IPv4               : Enabled            IPv6               : Enabled
Ping Response      : Enabled
-------------------------------------------------------------------------------
HTTP               : Disabled           HTTPS              : Enabled
FTP                : Disabled           Telnet             : Disabled
SSH/SCP            : Enabled            SNMPv1             : Disabled
SNMPv3             : Disabled           Modbus TCP         : Disabled
BACnet/IP          : Disabled
-------------------------------------------------------------------------------
Super User         : Enabled            RADIUS             : Disabled
Administrator      : Disabled           Device User        : Disabled
Read-Only User     : Disabled           Network-Only User  : Disabled


Type ? for command listing
Use tcpip command for IP address(-i), subnet(-s), and gateway(-g)

apc>tcpip -i 192.168.8.200
E002: Success
Reboot required for change to take effect.


* Reboot required for change to take effect.
apc>tcpip -s 255.255.255.0
E002: Success
Reboot required for change to take effect.


* Reboot required for change to take effect.
apc>tcpip -g 192.168.8.1  
E002: Success
Reboot required for change to take effect.


* Reboot required for change to take effect.
apc>reboot

3. 使用web界面配置剩余项目

注意：首次登陆使用 https 协议